Vibe FWD L4-1.8L VIN 8 (2004)
Knock Sensor: Description and Operation
Knock Sensor (KS) Operation
KNOCK SENSOR (KS) SYSTEM DESCRIPTION
The 1.8L engine is equipped with a knock sensor (KS) (1) that is located on the engine block behind the intake manifold (2). Ignition timing determines
the relationship between the time the spark plug is fired and the time that the piston reaches top dead center (TDC). TDC is the point in time when the
piston achieves maximum upward travel in the cylinder. If the spark plug ignites the compressed air/fuel mixture too late, not all of the air/fuel mixture
has time to burn while the fuel is highly compressed. Late ignition causes a decrease in fuel efficiency, decreased power, and increased exhaust
emissions. If the spark plug fires too soon, too much of the air/fuel mixture starts burning before the piston reaches the top of the compression stroke.
Early ignition of the air/fuel mixture causes detonation, commonly referred to as spark knock. Constant spark knock in the motor is undesirable.
Excessive spark knock can reduce engine performance. If severe enough, detonation can cause engine damage.
Every engine has an optimum ignition timing value. The optimum ignition timing is usually the earliest or most advanced firing of the spark plug that is
possible without causing detonation. An engines optimum ignition timing is designed to be the most advanced ignition timing possible during the most
demanding conditions. The optimum ignition timing is affected by all of the following variables:
-
The engine load
-
The engine temperature
-
The atmospheric pressure
-
The fuel quality
-
The fuel's octane rating
Ignition systems equipped with a knock sensor (KS) can be engineered for optimum ignition timing. A KS detects when the engine is experiencing
detonation and then signals the PCM to reduce the spark advance until detonation is no longer detected.
Non-Resonant Type Knock Sensor