Vibe FWD L4-1.8L VIN 8 (2004)
Power Steering Bleeding: Service and Repair
Bleeding the Power Steering System
Tools Required
-
J 35555 Mity Vac
-
J 43485 Power Steering Bleeder Adapter
Important: Hoses touching the frame, body, or engine may cause system noise.
1. Verify that the hoses do not touch any other part of the vehicle.
Notice:
Refer to Air in the Power Steering System Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Air In the Power Steering System Notice
Important: Loose connections may not leak, but could allow air into the steering system.
2. Verify that all hose connections are tight.
Important: Maintain the fluid level throughout the bleed procedure.
3. Remove the power steering fluid reservoir cap.
Notice:
Refer to Using Proper Power Steering Fluid Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Using Proper Power Steering Fluid Notice
Important: Use new fluid only.
4. Verify the fluid level is correct. Add fluid if necessary.
5. Attach the J 43485 to the J 35555 or equivalent.
6. Place the J 43485 on or in the reservoir filler neck.
7. Apply a vacuum of 68 kPa (20 in Hg) maximum.
8. Wait 5 minutes. Typical vacuum drop is 7 - 10 kPa (2 - 3 in Hg). If the vacuum does not remain steady, refer to Power Steering Fluid Leaks.
9. Remove the J 43485 and the J 35555.
10. Install the reservoir cap.
11. Start the engine. Allow the engine to idle.
12. Turn off the engine.
13. Verify the fluid level is correct. Adjust the fluid level if necessary.
Important: Do not turn steering wheel to lock.
14. Start the engine. Allow the engine to idle.
15. Turn the steering wheel 180 - 360 degrees in both directions 5 times.
16. Switch the ignition off.
17. Remove the reservoir cap.
18. Verify the fluid level is correct. Adjust the fluid level it necessary.
19. Attach the J 43485 to the J 35555 or equivalent.
20. Place the J 43485 on or in the pump reservoir filler neck.
21. Apply a vacuum of 68 kPa (20 in Hg) maximum.
22. Wait 5 minutes.
