Vibe FWD L4-1.8L VIN 8 (2004)
Tighten the shift select cable nut to 12 Nm (106 inch lbs.).
8. Install the front heat shield on the vehicle.
Tighten the heat shield bolts to 5 Nm (44 inch lbs.).
9. Install the front exhaust pipe assembly.
10. Lower the vehicle.
11. Install the SDM in the vehicle. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR.
12. Install the manual shift lever in the vehicle.
13. Connect the HO2S electrical connector.
14. Install the air cleaner assembly.
15. Connect the negative battery cable.
16. With the ignition switch in the LOCK position and the manual selector in the Park position, attempt to manually push the vehicle. Vehicle should
not move.
17. Verify that the vehicle CANNOT be driven in the Neutral position
18. Verify that the vehicle can be driven in D, 2, and L.
19. Verify that reverse gear DOES operate in R.
