Vibe FWD L4-1.8L VIN 8 (2004)
Transmission Position Switch/Sensor: Service and Repair
MU4
Park/Neutral Position Switch
Removal Procedure
1. Remove the shift cable retaining clip.
2. Disconnect the cable from the bracket.
3. Remove the shift cable retaining nut, then disconnect the cable from the manual lever.
4. Disconnect the PNP switch electrical connector (1) from the PNP switch.
5. Remove 1 nut, 1 lock washer and the manual lever from the manual shaft.
6. Unstake the lock plate (1) behind the manual shaft nut (3).
7. Remove the manual shaft nut and the lock plate from the PNP switch.
8. Remove the 2 bolts and the PNP switch from the transaxle.
Installation Procedure
1. Install the PNP switch to the transaxle. Secure with 2 bolts. Do NOT tighten fully.