Vibe FWD L4-1.8L VIN 8 (2004)
8. Place alignment marks on the universal joint flange (1).
9. Using a two jaw puller, remove the universal joint flange.
10. Remove the center support bearing and plate washer from the propeller shaft.
11. Turn the bearing by hand, check the bearing for smooth rotation.
12. Inspect the center bearing for wear or damage.
13. Inspect the seals for cracks or distortion.
Installation Procedure
1. Install the center support bearing, then the plate washer.
2. Align the alignment marks (1) on the universal joint flange and the intermediate shaft.
3. Notice: Refer to Fastener Notice in Cautions and Notices.
