Vibe FWD L4-1.8L VIN 8 (2004)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft Replacement - Two Piece
Propeller Shaft Replacement - Two Piece
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Place a reference mark on the pinion flange yoke and the differential pinion flange.
3. Remove the 4 bolts and the 4 nuts and washers.
4. Remove the mid shaft bearing support bolts (1,2).
5. Remove the sliding yoke (2) and the two piece propeller shaft assembly from the transmission.
6. Inspect the shaft for dents or other damage. Replace the shaft if the shaft is damaged.
7. Inspect the universal joints for smooth pivoting. If the universal joints bind or appear tight replace the universal joints as assembled.
8. Inspect the sliding yoke splines (1) for excessive wear or damage. If the splines (1) appear worn or rounded, replace the sliding yoke (3).
9. Inspect the sliding yoke for the following:
^
Scoring
^
Burrs
^
Other damage If the sliding yoke surface appears scored or rough, replace the sliding yoke.
10. Inspect the pinion flange yoke for the following:
^
Cracks
^
Distortion
^
Other damage If the pinion flange yoke appears damaged or distorted, replace the pinion flange yoke.
Installation Procedure
