Vibe FWD L4-1.8L VIN 8 (2004)
3. Using a brass bar and hammer, install the inner race on the outboard joint shaft.
4. Install a new snap ring.
5. Align the inboard joint shaft and outboard joint shaft.
6. Important: The grease capacity of the outboard joint is approximately 71 - 81g (2.5 - 2.9 oz.) which is yellow in color. The inboard joint grease
capacity is approximately 132 - 142g (4.7 - 5.0 oz.) which is gray in color.
Insert approximately 60 percent of the grease from the service kit into the outer joint.
1. Spread the grease onto the ball tracks, the balls, the cage and the inner race.
2. Spread the remainder of the grease into the bottom of the outer race.
3. Insert the remaining grease from the service kit into the boot.
7. Install a new retaining ring to the axle shaft.
