Vibe FWD L4-1.8L VIN 8 (2004)
8. Install the boots into the shaft grooves.
9. Ensure that the drive shaft is at standard length.
The standard length is approximately 688.33 - 698.33 mm (27.098 - 27.492 inch).
10. Position the small boot retaining clamp onto the neck of the boot.
11. Position the small boot and small retaining clamp to the axle shaft.
12. Notice: Refer to Fastener Notice in Cautions and Notices.
Using the J 42572 , crimp the small boot retaining clamp.
13. Position the large boot retaining clamp onto the boot.
14. Position the boot and large retaining clamp to the joint outer race.
15. Important: The boot must not be dimpled, stretched or out of shape in any way.
Inspect the boot for proper shape. If the boot is NOT shaped correctly, equalize the pressure in the boot by lifting the boot edge slightly and shape
the boot properly by hand.
16. Inspect the boot for damage. If the boot has been cut or punctured during assembly, you must discard and replace the boot.
17. Important: The boot retaining clamp must not be over-tightened or under-tightened.
Using the J 42572 , crimp the large boot retaining clamp.
18. Inspect the outer CV joint and wheel drive shaft for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the outer joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
