Vibe FWD L4-1.8L VIN L (2005)
Antenna Cable: Service and Repair
Antenna Cable Replacement
ANTENNA CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the center pillar lower trim panel.
2. Adjust the carpet for access to the wiring harness as required.
3. Disconnect the antenna extension lead (1) from the main body harness coaxial cable (2).
4. Remove the rear quarter upper trim panel.
5. Disconnect the coaxial cable from the radio antenna and from the rear window defog control module.
6. Cut off the visible end of the coaxial antenna cable from the wiring harness in the rear quarter upper area.
7. Cut off the visible end of the coaxial antenna cable from the wiring harness in the front kick plate area.
INSTALLATION PROCEDURE
1. Install the coaxial antenna cables into the vehicle.
2. Use electrical tape in order to secure the antenna extension cable to the top of the wiring harness. Secure the cable to the harness at least every 150
mm (6 in).