Vibe FWD L4-1.8L VIN L (2005)
18. Slide each drive cable bracket (1) forward, with the actuator cable attached, out of the sunroof housing (2) guide rails.
INSTALLATION PROCEDURE
1. Slide each drive cable bracket (1) rearward, with the actuator cable attached, into the sunroof housing (2) guide rails. Make sure the outer guide
pins are inserted into the housing guide rail slots.
2. Install the sunroof guide blocks to the housing.
3. Install the sunroof housing front support (1) to the sunroof housing (2). Secure the support with the 6 screws.
4. Install the 2 screws which secure each sunroof guide block (1) to the sunroof housing (2).
5. Install the sunroof housing rear support (1) by sliding the support into the sunroof housing (2).
