Vibe FWD L4-1.8L VIN L (2005)
1. Inspect the brake fluid level in the brake master cylinder reservoir.
2. Clean the outside of the reservoir and the reservoir cap in order to avoid dirt contamination of the brake fluid.
3. Remove the reservoir cap.
Important:
^
If the brake fluid is above the MAX mark, do not add brake fluid.
^
If the brake fluid is below the MIN mark during a routine fluid inspection, inspect the brake system for wear and potential brake fluid
leaks.
^
If the brake fluid level is below the MIN mark, the brake pads are not worn, and there are no brake fluid leaks, add brake fluid to the MAX
mark.
4. Fill the reservoir until the brake fluid reaches the MAX mark.
5. Install the reservoir cap.
