Vibe FWD L4-1.8L VIN L (2005)
17. Rotate the crankshaft clockwise one revolution. Ensure that the plunger on the timing chain tensioner has released.
18. Complete the following steps if the plunger does not release:
18.1.
Use a screwdriver or your finger in order to press the timing chain dampener into the timing chain tensioner.
18.2.
Release the hook from the pin.
18.3.
Verify proper timing chain alignment after the plunger has released.
19. Install the cylinder head cover.
20. Install the right side engine mount.
21. Lower the A/C receiver. Tighten the pinch clamps.
22. Remove the engine support fixture.
23. Install the generator.
24. Fill the cooling system.
25. Connect the negative battery cable.
^
Tighten the battery cable bolt to 15 Nm (11 ft. lbs.).