Vibe FWD L4-1.8L VIN L (2005)
19. Install the power steering pump.
20. Use the following fasteners in order to secure the power steering pump:
^
The 2 bolts (1)
^
The 2 nut.
^
Tighten the power steering pump bolts to 36 Nm (27 ft. lbs.).
21. Install the right side engine splash shield.
22. Lower the vehicle.
23. Connect the power steering oil pressure switch connector.
24. Rotate the crankshaft clockwise one revolution. Ensure that the plunger on the timing chain tensioner has released. Complete the following steps if
the plunger does not release:
^
Use a screwdriver or your finger in order to press the timing chain dampener into the timing chain tensioner.
^
Release the hook from the pin.
^
Verify proper timing chain alignment after the plunger has released.
25. Install the cylinder head cover.
26. Install the right side engine mount.
27. Lower the A/C receiver. Tighten the pinch clamps.
