Vibe FWD L4-1.8L VIN L (2005)
Exhaust Pipe: Service and Repair
Front Pipe Replacement
Removal Procedure
1. Remove the oxygen sensors.
2. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
3. Remove the floor panel brace.
4. Remove the following components from the exhaust manifold:
^
The 2 bolts
^
The 2 springs
5. Remove the following components from the front pipe to the Three Way Catalytic Converter (TWC) exhaust pipe:
^
The 2 bolts
^
The 2 springs
6. Remove the front pipe from the front pipe hanger (2).
7. Remove the front pipe from the vehicle.
8. Clean the gasket and seal the mating surfaces.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the front pipe to the vehicle.
