Vibe FWD L4-1.8L VIN L (2005)
Hose/Line HVAC: Service and Repair
Compressor Hose Assembly Replacement
COMPRESSOR HOSE ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT: When installing a new hose assembly add 30 ml (1.0 fl oz) of refrigerant oil to the refrigeration system.
1. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
IMPORTANT: Cap the open fittings to prevent dirt and moisture from entering the refrigeration system.
2. Remove the bolt (11) and the condenser inlet tube (12) from the condenser.
3. Remove the bolt (7) and the compressor hose assembly from the compressor (6).
4. Remove the 2 nuts (2) and the hose brackets from the vehicle.
5. Remove the suction line (3) from the evaporator tube.
6. Remove the compressor hose assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install new O-rings lubricated with 525 viscosity mineral oil.
2. Position the compressor hose assembly into the vehicle.
3. Install the suction line (3) to the evaporator tube.
NOTE: Refer to Fastener Notice in Service Precautions.
