Vibe FWD L4-1.8L VIN L (2005)
1. Connect the front end sensor - left electrical connector (1) from the front end sensor - left (2).
2. Connect the CPA from the front end sensor - left connector.
3. Connect the front end sensor - right electrical connector (1) from the front end sensor - right (2).
4. Connect the CPA from the front end sensor - right connector.
5. Connect the battery negative cable.
6. Install the AM2 Fuse into the junction block (1).
7. Use caution while reaching in and turn the ignition switch to the ON position.
8. The AIR BAG indicator will flash then turn OFF.
9. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information.
SIR Disabling and Enabling Zone 2
SIR DISABLING AND ENABLING ZONE 2
DISABLING ZONE 2
1. Turn the steering wheel so that the vehicle wheels are pointing straight ahead.
