Vibe FWD L4-1.8L VIN L (2005)
11. Remove the quarter upper trim panel.
12. Remove the center pillar upper trim panel.
13. Disconnect the right roof rail module wiring harness yellow connector (2) from the right roof rail module (1).
ENABLING ZONE 6
1. When enabling the SIS or seat belt pretensioner go to step 2, if the right roof rail module needs enabling go to step 7.
2. Connect the SIS electrical connector.
3. Install the front seat belt retractor.
4. Install the center pillar lower trim panel.
5. Install the rear door sill plate.
6. Install the front door sill plate.
7. Connect the right roof rail module wiring harness yellow connector (2) to the right roof rail module (1).
8. Install the center pillar upper trim panel.
9. Install the quarter upper trim panel.
10. Connect the battery negative cable.
11. Install the AM2 fuse into the junction block (1).
12. Use caution while reaching in and turn the ignition switch to the ON position.