pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

SIR Disabling and Enabling Zones|Page 1163 > < SIR Disabling and Enabling Zones|Page 1161
Page 6
background image

6. Release the inflatable restraint steering wheel module coil connector locking mechanism.
7. Disconnect the inflatable restraint steering wheel module coil connector C3 (1).

ENABLING ZONE 3

1. Install the yellow 2-way connector (1) for the inflatable restraint steering wheel module coil.Connect the connector and lock the connector with the

connector lock lever.

2. Install the lower steering column trim cover.
3. Connect the battery negative cable.

4. Install the AM2 fuse into the junction block (1).
5. Use caution while reaching in and turn the ignition switch to the ON position.
6. The AIR BAG indicator will flash then turn OFF.
7. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Refer to Diagnostic

System Check - Vehicle in Vehicle DTC Information.

SIR Disabling and Enabling Zone 4

SIR DISABLING AND ENABLING ZONE 4

DISABLING ZONE 4

1. Turn the steering wheel so that the vehicle wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.

3. Locate and remove the AM2 fuse from the junction block (1), which is located near the base of the steering column.

SIR Disabling and Enabling Zones|Page 1163 > < SIR Disabling and Enabling Zones|Page 1161