Vibe FWD L4-1.8L VIN L (2005)
-
Denso Type SK20R11
-
NGK Type IFR6A11
2. Set the spark plug gap. Bend only the side electrode.
1.0-1.1 mm (0.040-0.043 in)
1.3 mm (0.051 in)
IMPORTANT:
-
Do not touch the tip of the spark plug.
-
Do not damage the iridium surface of the electrode when gapping the plug.
-
Do not adjust the gap on used spark plugs. Replace the spark plug if the gap is greater than specification.
3. Install the spark plugs to the cylinder head.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the spark plugs to 18 N.m (13 lb ft).
4. Install each ignition coil (3) to the cylinder head cover.
5. Secure the ignition coils using the bolts (4).
Tighten the bolts to 9 N.m (80 lb in).
6. Connect each ignition coil electrical connector.
7. Install the engine cover (1) to the engine.
8. Secure the engine cover (1) with the four fasteners.
Tighten the fasteners to 7 N.m (62 lb in).
