Vibe FWD L4-1.8L VIN L (2005)
6. Double click on the: CUW icon on the desktop to access the Vibe Programming application.
OR
Click on the: Start icon.
7. Select: Programs.
8. Select: Vibe Programming Application.
9. Select: Vibe Programming.
10. The Calibration Update Wizard-Screen S701-02 box will appear.
1. Click: File Open.
2. An Insert disk box will appear. Click: Cancel.
11. The Calibration Update Wizard-Screen S701-12 box will appear.
1. Select: Desktop in the: Look in field.
2. Select: Pontiac Vibe folder and click: Open.
3. The Look in field will change to: Pontiac Vibe.
12. The Calibration Update Wizard-Screen S701-06 box will appear (Connect to Vehicle).
1. At the select MDI or J-2534 device Tool , select: ETAS MDI in the drop down menu.
2. Click: Next.
13. The Calibration Update Wizard-Screen S701-08 box will appear (Establishing communication with the vehicle). The Device Explorer box will
appear, listing all the available MDIs.
1. In the Device Explorer box, select the: MDI that is configured to the PC and is connected to the vehicle.
2. Click: Next.
14. The Calibration Update Wizard-Screen S701-09 box will appear (Calibration Selection Confirmation).
1. Review all of the information in this box.
2. Click: Next.
15. The Calibration Update Wizard-Screen S701-47 box will appear (Verify Calibration ID Numbers).
1. Review all of the information in this box.
2. Click: the old calibration under the Target Cal ID column.
3. Click: Next.
16. The Calibration Update Wizard-Screen S701-14 box will appear (Vehicle Preparation).
1. Review all of the information in this box.
2. Turn OFF the ignition.
3. Click: Next.
17. The Calibration Update Wizard-Screen S701-15 box will appear (Prepare for Reprogramming).
1. Review all of the information in this box.
2. Turn ON the ignition, with the engine OFF.
3. Click: Start.
18. The Calibration Update Wizard-Screen S701-17 box will appear (Flash Calibration Update in Process).
Wait for the update process to complete.
19. The Calibration Update Wizard-Screen S701-22 box will appear (Flash Calibration Update Successful).
1. Review all of the information in this box.
2. Turn OFF the ignition.
3. Click: Next.
20. The Calibration Update Wizard-Screen S701-23 box will appear (Prepare for verifying vehicle).
1. Review all of the information in this box.
2. Turn ON the ignition with the engine OFF.
3. Click: Next.
21. The Calibration Update Wizard-Screen S701-25 box will appear (Establishing communication with the vehicle).
