pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

A/C - MIL/Check Engine Light On DTCs P060/P0138|Page 2050 > < Manifold Pressure/Vacuum Sensor|Diagrams|Page 2041
Page 1
background image

Oxygen Sensor: All Technical Service Bulletins
A/C - MIL/Check Engine Light On DTCs P060/P0138

TECHNICAL

Bulletin No.: 10-06-04-010

Date: July 22, 2010

Subject: Intermittent MIL/Check Engine Light On, DTCs P0607 and/or P0138, Vehicle Stability Control Lamp On, Driveability Concerns in High
Ambient Temperatures with A/C On (Clean HO2S Connector and Inspect/Unplug Evaporator Drain Tube)

Models:

2003-2010 Pontiac Vibe
Equipped with AWD or FWD

Condition

Some customers may comment on an intermittent MIL/check engine light and/or an illuminated vehicle stability control light. They may also comment
about driveability concerns in high ambient temperatures with the A/C on.

Upon further diagnosis, a technician may find DTC P0607 and/or P0138.

Cause

This condition may be caused by water leaking from the evaporator onto the electrical connector in the center IP area. The evaporator drain may be
restricted, causing water to drip from the evaporator case onto the post HO2S connector. This creates a path for current to flow from the heater circuit to
the HO2S signal circuit. There may not be carpet wet from this leak, only the connector.

Correction

Note

The drainage from the HVAC case may not be extensive enough to cause wet carpet or other damage.

1. Remove the side IP panel (1) then move the carpet back to gain access to the HO2S connector.

2. Locate the HO2S connector (1). Clean the connector with compressed air and apply a small amount of silicone grease to the connector.

A/C - MIL/Check Engine Light On DTCs P060/P0138|Page 2050 > < Manifold Pressure/Vacuum Sensor|Diagrams|Page 2041