Vibe FWD L4-1.8L VIN L (2005)
7. Connect the left roof rail module wiring harness yellow connector (2) to the left roof rail module (1).
8. Install the center pillar upper trim panel.
9. Install the quarter upper trim panel.
10. Connect the battery negative cable.
11. Install the AM2 Fuse into the junction block (1).
12. Use caution while reaching in and turn the ignition switch to the ON position.
13. The AIR BAG indicator will flash then turn OFF.
14. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle.
