Vibe FWD L4-1.8L VIN L (2005)
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS) Replacement
^
Tools Required
-
J 36850 Transmission Assembly Lubricant
Removal Procedure
1. Caution: Refer to Battery Disconnect Caution in Service Precautions.
Disconnect the negative (-) battery cable.
Vehicle Speed Sensor
2. Disconnect the vehicle speed sensor (VSS) electrical connector.
3. Remove the 1 retaining bolt (1) and the VSS (2) from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
Installation Procedure
1. Apply J 36850 to the VSS O-ring.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).
^
Tighten the VSS speed sensor (VSS) bolt to 6 Nm (53 inch lbs.).
Vehicle Speed Sensor
3. Connect the VSS electrical connector.
4. Connect the negative (-) battery cable.