Vibe FWD L4-1.8L VIN L (2005)
Positive: Service and Repair
Battery Positive Cable Replacement
BATTERY POSITIVE CABLE REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
IMPORTANT: Whenever battery cables are being replaced, always be certain to use a replacement cable that is the same type, size and length.
Some positive (+) cables have additional teed wires attached to them and some negative (-) cables have additional ground leads attached. Always be
certain to route the replacement battery cable in exactly the same manner as the original cable.
1. Remove the battery from the vehicle.
2. Remove the plastic insulator from the positive (+) battery terminal.
3. Remove the nut (5) from the positive (+) battery cables.
4. Separate the positive (+) battery cable (4) from the battery positive fuse block feed cable.
5. Remove the positive (+) battery cable harness loom from the harness retainers.
6. Remove the positive (+) battery cable from the harness loom being careful not to damage the other wires in the harness.
7. Disconnect the retaining nut and the cable from the starter solenoid.
8. Remove the cable from the vehicle.
INSTALLATION PROCEDURE
1. Position the positive (+) battery cable (4) into the vehicle.
2. Route the positive (+) cable into the harness loom.
