Vibe FWD L4-1.8L VIN L (2005)
19. Install the bolt (3).
Tighten the bolt to 113 N.m (83.3 lb ft).
20. Remove the jack from the crossmember.
21. Install the 2 nuts (2, 5) and the bolt (6).
Tighten the nuts and the bolt to 52 N.m (38.4 lb ft).
22. If you are installing the crossmember WITHOUT the steering gear, complete the following steps:
1. Install the 2 nuts (6, 7) and the 2 bolts (12, 13).
Tighten the bolts to 127 N.m (93.7 lb ft).
2. Remove the wire from the steering gear (11).
23. Install the following to the left front control arm:
*
The 2 nuts (1, 2)
*
The bolt (3)
Tighten the 2 nuts and the bolt to 89 N.m (65.6 lb ft).
24. Install the following to the right front control arm:
*
The 2 nuts
*
The bolt
Tighten the 2 nuts and the bolt to 89 N.m (65.6 lb ft).
25. Install the left engine splash shield. Refer to Splash Shield Replacement - Engine - Left (See: Body and Frame/Splash Guard/Service and
Repair/Splash Shield Replacement - Engine - Left) in Body Front End.
26. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine - Right (See: Body and Frame/Splash Guard/Service and
Repair/Splash Shield Replacement - Engine - Right) in Body Front End.