Vibe FWD L4-1.8L VIN L (2005)
*
The 2 stabilizer shaft link nuts
*
The 2 stabilizer shaft links
*
The 4 stabilizer clamp bolts
*
The 2 stabilizer clamps
*
The 2 stabilizer shaft insulators
*
The stabilizer shaft
20. If you removed the crossmember WITH the steering gear, remove the steering gear from the crossmember. Refer to Power Steering Gear
Replacement (FWD) Power Steering Gear Replacement (AWD) in Power Steering System.
Installation Procedure
1. If you are installing the crossmember WITH the steering gear, install the steering gear to the crossmember. Refer to Power Steering Gear
Replacement (FWD) Power Steering Gear Replacement (AWD) in Power Steering System.
2. Install the following components to the crossmember. Refer to Stabilizer Shaft Replacement (FWD) Stabilizer Shaft Replacement (AWD) .
*
The 2 stabilizer shaft link nuts
*
The 2 stabilizer shaft links
*
The 4 stabilizer clamp bolts
*
The 2 stabilizer clamps
*
The 2 stabilizer shaft insulators
*
The stabilizer shaft
Important: DO NOT tighten the nut and bolts completely. The weight of the vehicle must be on the tire and wheel assemblies before
tightening the nut and the bolts.
3. Install the following components to the crossmember:
*
The left lower control arm (2)
*
The 2 bolts (1, 4)
*
The nut (3)
Important: DO NOT tighten the nut and bolts completely. The weight of the vehicle must be on the tire and wheel assemblies before
tightening the nut and the bolts.
4. Install the following components to the crossmember:
*
The right lower control arm
*
The 2 bolts
*
The nut
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Install the trans support and the 2 bolts to the crossmember.
Tighten the bolts to 52 N.m (38.4 lb ft).
6. Use a jack in order to raise and support the crossmember with the attached components as a unit.