Vibe FWD L4-1.8L VIN L (2005)
Important: When the manual selector knob is lifted upward, the shift knob button will be released under slight spring pressure.
6. Gently raise the manual selector knob upward, then remove the manual selector knob button
7. Remove the manual selector knob sleeve retaining screw, then remove the selector sleeve.
8. Using a small screwdriver, gently pry the overdrive switch from the manual selector knob, then slowly pull the wires out of the knob.
Installation Procedure
1. Install the OVERDRIVE switch wires into manual selector knob.
2. Snap the OVERDRIVE switch into the manual selector knob.
3. Install the OVERDRIVE wires through the manual selector lever sleeve, then secure the sleeve with the lower screw.
