Vibe FWD L4-2.4L (2009)
recall bulletins 10018 and 10038. To determine if the vehicle is equipped with a second design accelerator pedal, measure the length of the accelerator
pedal in the area indicated in the arrow span. Refer to the illustration.
-
If the length of the accelerator pedal in the arrow span area is 70 mm (2.76 in), the accelerator pedal has been modified or is a second design
pedal. Do NOT modify the accelerator pedal. Proceed to the Floor Carpet Modification procedure in this bulletin.
-
If the length of the accelerator pedal in the arrow span area is longer than 70 mm (2.76 in), the accelerator pedal has NOT been modified and is a
first design accelerator pedal. Proceed to the next step.
Caution: Accelerator Pedal Handling Notes
-
DO NOT drop.
-
Avoid vibration and shock.
-
DO NOT place sensor in vise.
-
Cover and uncover the sensor while in the vehicle to prevent damage and debris from entering.
-
DO NOT reuse an accelerator pedal that has been dropped.
Note
-
For additional information on accelerator pedal removal, please refer to SI.
-
Be sure to use bubble wrap to protect the sensor.
-
Be sure to seal the bubble wrap with masking tape to prevent damage to the sensor, and cutting debris from entering the pedal's movable lock.
-
DO NOT reuse the bubble wrap.
1. Remove the accelerator pedal assembly.
1. Disconnect the accelerator pedal connector.
2. Remove the 2 bolts.
3. While still inside the vehicle, use bubble wrap (1) and masking tape (2) to cover and protect the sensor.
Note
-
DO NOT mark the area beyond the template.
-
Use a flat tip screwdriver or marker if a scribe is not available.
-
Never cut or sand the pedal while the template is on the pedal.
2. Mark the area to be cut. Firmly set the template (2) to the pedal and scribe guidelines (1) to outline the area to be cut.
Note
