Vibe FWD L4-2.4L (2009)
Discard the piston boot.
4. Wrap tape on a flat blade tool.
5. Use a taped flat blade tool (1) in order to remove the piston seal from the caliper.
Discard the piston seal.
6. Remove the bleeder valve cap.
7. Remove the bleeder valve.
Inspection Procedure
1. Clean the caliper housing (1) and the caliper piston (3) in denatured alcohol or an equivalent brake parts cleaner:
2. Dry the components and all the passages in the caliper housing using unlubricated, compressed air.
3. Inspect the piston bore and the slide pin bores of the caliper for damage, wear or corrosion. Replace the caliper assembly if damage, wear or
corrosion is evident.
4. Inspect the piston and the caliper housing for damage, wear or corrosion. Replace the components if damage, wear or corrosion is evident.
Assembly Procedure