Vibe FWD L4-2.4L (2009)
3. Ensure the cylinder boot (1) is installed in the groove of the piston. If necessary, refer to Rear Brake Caliper Overhaul (All Wheel Drive and GT)
(See: Brake Caliper/Service and Repair/Overhaul/Rear Brake Caliper Overhaul)Rear Brake Caliper Overhaul (Except All Wheel Drive and GT) (
See: Brake Caliper/Service and Repair/Overhaul/Rear Brake Caliper Overhaul).
4. Apply disc brake grease to the pad side of the 2 inner insulators (2, 5).
5. Ensure the disc brake grease covers the area where the inner insulators contact the brake pads (3, 4).
6. Install the 2 inner insulators to the 2 brake pads.
7. Install the 2 outer insulators (1, 6) to the 2 inner insulators.