Vibe FWD L4-2.4L (2009)
Discard the brake hose retainer.
11. Install a cap or a plug to the brake pipe fitting in order to prevent brake fluid loss and contamination.
12. Remove the bolt and separate the brake hose (1) from the bracket.
13. Remove the brake hose from the vehicle.
Installation Procedure
1. If you are reusing the brake hose, align the tags or marks in order to install the hose in the correct position.
If you are installing a new brake hose, verify the part number.
2. Remove the cap or the plug from the caliper.
3. Install a NEW brake hose gasket and the brake hose to the caliper.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the fitting (1) and tighten to 29 Nm (21 lb ft).
5. Remove the cap or the plug from the brake pipe.
