Vibe FWD L4-2.4L (2009)
1. Apply a light coat of engine oil to the O-ring (1) on the crankshaft position sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the crankshaft position sensor (4) with the bolt and tighten to 9.0 Nm (80 lb in).
Note: Do not twist the O-ring.
3. Install the wire harness (3) and crankshaft position sensor connector clamp.
4. Connect the crankshaft position sensor connector (2).
5. Install the generator assembly. Refer to Generator Replacement (2.4L) (See: Starting and Charging/Charging System/Alternator/Service and
Repair)Generator Replacement (1.8L) (See: Starting and Charging/Charging System/Alternator/Service and Repair)
6. Install the right engine under cover.
7. Connect cable to negative battery terminal.
8. Inspect for oil leak.