Vibe FWD L4-2.4L (2009)
10. Install the front No. 1 console box insert.
-
Engage the guide.
-
Engage the 3 claws and install the front No. 1 console box insert.
Reinstall the Accelerator Pedal Assembly
1. Reinstall the accelerator pedal assembly.
Note
-
DO NOT reuse the bubble wrap.
-
For additional information on accelerator pedal installation, refer to SI.
1. Remove and discard the masking tape and bubble wrap from the accelerator pedal assembly while it is inside the vehicle.
2. Reinstall the pedal with the 2 bolts and torque to specification.
Torque Specification
5.5 Nm (49 lb in)
3. Reconnect the accelerator pedal connector.
Make sure there is clearance between the ruler and the floor.
Cross Section View
Ruler
Floor Carpet
Clearance Between Ruler and Floor
2. Inspect the floor carpet.
1. Depress the accelerator pedal fully and place a ruler at the front tip of the pedal as shown in the illustration, and then make sure that there is a
clearance between the ruler and the floor.
2. If no clearance exists, reshape the carpet again.
3. Confirm a claw and all fasteners are securely fixed with floor carpet.
