Vibe FWD L4-2.4L (2009)
-
DO NOT place the sensor in the vise to avoid damage.
-
Firmly secure the pedal to prevent it from moving.
-
DO NOT over tighten the vise.
Upper View
Tip Side View
Side View
3. Set the pedal in the vise at a right angle using a shop cloth while avoiding the sensor.
Note
-
Always wear protective eyewear and gloves when cutting and sanding.
-
Guide cut must be straight and clean.
4. Cut lower section accelerator pedal assembly.
1. The cut line (1) is slightly outside from the scribed line and it makes 90 degree to the pedal foot pad as shown in the illustration.
2. Use a hack-saw (2) and cut the pedal 5 mm (0.2 in) deep (1) as guide groove for reciprocating saw.
Note
