Vibe FWD L4-2.4L (2009)
7. Sand the radius line.
Note
-
Always wear protective eyewear and gloves when cutting and sanding.
-
Guide cut must be straight and clean.
Using orbital sander, sand to the scribed radius line and remove any sharp edges and burrs.
Caution
DO NOT sand pedal stopper area (circled) as shown in illustration.
8. Sand the lower corner near pedal stopper.
1. Remove the pedal from the vise. Turn the pedal over with the foot pad facing down and set pedal in the vise using a shop cloth while avoiding
the sensor.
Note
Always wear protective eyewear and gloves when sanding.
2. Using an orbital sander and hand file, sand the lower corner near pedal stopper.
9. Remove all burrs from the cut surfaces.
