Vibe FWD L4-2.4L (2009)
4. Remove burrs.
Cut Line
Tibia Marking Gauge
Note
Use an orbital sander and file and trim exactly along the cut line.
5. Place the gauge to the reshaped tibia pad and check if it fits the tibia marking gauge.
Note
Remove all debris and burrs. This is in preparation for when installing the carpet protector (rubber seat).
6. Clean the cut surface.
5. Reshape the floor carpet.
Caution
-
A bolt extends from the floor under the floor carpet. Be careful not to bore a hole in the floor carpet when reshaping.
-
Keep the hair dryer/heat gun more than 200 mm (7.87 in) away from the floor carpet, and stop after 2 or 3 minute intervals. Continuous heating
