Vibe FWD L4-2.4L (2009)
1. Install the heated oxygen sensor for AWD.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and the J-39194-C - wrench with
30 mm (1.18 in). This torque value is effective when the J-39194-C - wrench is parallel to the torque wrench.
2. Using the J-39194-C - wrench (1) , install the heated oxygen sensor and tighten.
*
Without the J-39194-C - wrench to 44 Nm (32 lb ft)
*
With the J-39194-C - wrench to 40 Nm (30 lb ft)
3. Connect the wire harness grommet.
4. Connect the heated oxygen sensor connector.
5. Install heated oxygen sensor for FWD.