Vibe FWD L4-2.4L (2009)
53. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gauge) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
54. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
55. Twist together one end from each of the wires in order to short the wires.
56. Twist together 2 connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
Component Connector End Views (See: Diagrams/Connector Views) in order to determine the correct circuits.
57. Inspect that the 3 wire connection is secure.
58. Bend flat the twisted connection.
59. Secure and insulate the 3 wire connection to deployment harness using electrical tape.
