Vibe FWD L4-2.4L (2009)
12. Inspect the J 38826 SIR Deployment Harness and the appropriate pigtail adapter for damage. Replace as needed.
13. Short the 2 SIR deployment harness leads (1) together using one banana plug seated into the other.
14. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
15. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
16. Connect the inflator module to the adapter (2) on the SIR deployment harness (1).
17. Place a 12-volt minimum/2-amp minimum power source (i.e., vehicle battery) near the shorted end of the harness.
Note:
*
The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the immediate area that you intend
to deploy the inflator module.
*
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator
module due to the force of the rapid expansion of gas inside the inflator module.
*
If you are deploying a dual stage inflator module with stage 1 already deployed, the fixture may not move and the noise may have been
reduced.
18. Clear the area of people.
