Vibe FWD L4-2.4L (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
Removal Procedure
1. Disconnect cable from negative battery terminal. refer TO Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair)
2. Remove the right engine under cover.
3. Remove the generator assembly. Refer to Generator Replacement (2.4L) (See: Starting and Charging/Charging System/Alternator/Service and
Repair)Generator Replacement (1.8L) (See: Starting and Charging/Charging System/Alternator/Service and Repair)
4. Disconnect the crankshaft position sensor connector (1).
5. Separate the crankshaft position sensor connector clamp and wire harness (3).
6. Remove the bolt and crankshaft position sensor (4).
Installation Procedure