Vibe FWD L4-2.4L (2009)
2. Cut the 2 terminals (2,3) that connect the battery (1) to the base board. The battery and the base board are covered in silicone.
3. Remove the battery.
4. Dispose of the battery properly.
Installation Procedure
1. Write down the identification number (1).
2. If you are replacing the tire pressure indicator sensor, install a NEW grommet. Install the grommet to the tire pressure indicator sensor valve stem.
Note: If the tire pressure indicator sensor is improperly installed, the sensor may not transmit signals while the vehicle is driven at high speed.
3. Install the sensor to the valve stem hole in the wheel. Insert the sensor from the inside of the wheel toward the outside of the wheel. Ensure the
printed surface (2) is visible.
4. If you are replacing the sensor, install a NEW washer (3). Install the washer to the sensor valve stem.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).