Vibe FWD L4-2.4L (2009)
Alignment: Service and Repair
Rear Camber and Toe Adjustment
Rear Camber and Toe Adjustment
1. Loosen the nut on the upper control arm cam bolt.
2. Loosen the nut on the lower control arm cam bolt.
3. Rotate the cam bolts in order to adjust the camber and the toe to the specification. Refer to Wheel Alignment Specifications (See: Specifications).
4. Measure the distance (b) from the lower left control arm bracket bolt to the right rear crossmember bolt.
5. Measure the distance (a) from the lower right control arm bracket bolt to the left rear crossmember bolt.
6. Verify the difference between measurement (a) and measurement (b) are within the specification.
The difference between measurement (a) and measurement (b) should be 6 mm (0.24 in) or less.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Tighten the nuts on the control arm cam bolts to 74 Nm (54.6 lb ft).
8. Measure the alignment.
9. Adjust the rear camber and toe if necessary.
