Vibe FWD L4-2.4L (2009)
13. Use paint in order to place match marks (2) on the tie rod ends and on the inner tie rods.
14. Remove the cotter pin from the left side tie rod end ball stud.
15. Loosen the left side tie rod end nut (1).
16. Use the J-6627-A - puller , or equivalent, in order to separate the left side tie rod end from the knuckle.
17. Remove the left side tie rod nut.
18. Remove the cotter pin from the right side tie rod end ball stud.
19. Loosen the right side tie rod nut.
20. Use the J-6627-A - puller , or equivalent, in order to separate the right side tie rod end from the knuckle.
21. Remove the right side tie rod nut.
22. Use a wrench in order to hold the left front stabilizer shaft link stud. Remove the nut from the stud and separate the link (3) from the left front strut
bracket (1).
23. Use a wrench in order to hold the right front stabilizer shaft link stud. Remove the nut from the stud and separate the link from the right front strut.
24. Remove the bolt (3) and the 2 nuts (1, 2) from the left front control arm.
25. Remove the bolt and the 2 nuts from the right front control arm.
