Vibe FWD L4-2.4L (2009)
Note: Do not tighten the tie bar bracket nuts yet.
3. If equipped with the strut housing upper tie bar, install the tie bar bracket and the 3 nuts (1, 2, 3) to the studs on the top of the strut.
4. If equipped, install the strut housing upper tie bar. Refer to Strut Housing Upper Tie Bar Replacement (See: Strut Housing Upper Tie Bar
Replacement).
5. If equipped, tighten the 3 nuts on the tie bar bracket to 50 Nm (37 lb ft).
6. Install the strut cover to the top of the strut mount.
7. Hold the bolts with a wrench and tighten the nuts on the lower side of the strut assembly to 240 Nm (177 lb ft).
8. Install the ABS wheel speed sensor to the knuckle. Refer to Front Wheel Speed Sensor Replacement (See: Brakes and Traction Control/Antilock
Brakes / Traction Control Systems/Wheel Speed Sensor/Service and Repair).
9. Install the speed sensor wire (3) and the bracket (2) to the strut. Ensure the wire is not twisted.
10. Install the front brake hose (4) to the bracket on the strut. Ensure the hose is not twisted.
11. Install the bolt (1) to the bracket and tighten to 29 Nm (21 lb ft).
12. Install the nut and the stud to the bracket (1) in order to connect the link (3) to the strut. Use a wrench in order to hold the front stabilizer shaft link
