Vibe FWD L4-2.4L (2009)
5. Install the brake shield (3) to the knuckle (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the 3 bolts (4,5,7) that retain the brake shield to the knuckle.
Tighten the bolts to 8.3 Nm (73.46 lb in).
7. Place the CH-49684-2 (3) on a press support plate.
8. Place the hub (2) on the CH-49684-2.
9. Place the knuckle and bearing assembly on the hub.
10. Place the CH-49684-1 (1) on the bearing.
11. Use a press in order to install the hub to the bearing.
Press from the inboard side of the bearing toward the outboard side of the hub.
12. Use snap ring pliers in order to install the wheel bearing retainer.
13. If the vehicle is equipped with a front wheel bearing inner seal shield, complete the following steps:
