Vibe FWD L4-2.4L (2009)
Installation Procedure
1. Position the wiper motor assembly to the liftgate.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution)
2. Install the three bolts (1) to the wiper motor assembly and tighten to 5.5 Nm (49 lb in).
3. Connect the electrical connector (2).
4. Apply multi-purpose grease to the entire surface of the wiper motor grommet lip (1).
Note: Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.
