911 Carrera (997) F6-3.6L (2006)
Disengaging control unit at both plates
3. Push control unit forward in "direction of travel" and disengage it from the support for the steering wiring.
WARNING:
Risk of damage to electronic control modules.
-
If care is not taken, electrical and electronic components may be destroyed.
-
Before removing the control module, switch off the ignition and remove the ignition key.
NOTE: Depending on the vehicle equipment, the control unit has one or two connectors.
Releasing and unplugging connectors
4. Release both electrical connectors -1, 2- -A- and unplug them from the control unit.
5. Take out the control unit.
Installing KESSY/PAS control unit
WARNING:
Risk of damage to electronic control modules.
-
If care is not taken, electrical and electronic components may be destroyed.
-
Before removing the control module, switch off the ignition and remove the ignition key.
NOTE: Depending on the vehicle equipment, the control unit has one or two connectors.
Inserting the connectors
1. Press both electrical connectors -1, 2- into control unit and lock them until they are felt to engage.