911 Carrera (997) F6-3.6L (2006)
Tow Sensor: Procedures
966319 Removing And Installing Tilt Sensor Control Unit
Preliminary work
Remove centre console cover.
Removing tilt sensor control unit
Overview of tilt sensor control unit
NOTE: The tilt sensor is integrated into the tilt control unit and cannot be separately replaced.
WARNING:
Risk of damage to electronic control modules.
-
If care is not taken, electrical and electronic components may be destroyed.
-
Before removing the control module, switch off the ignition and remove the ignition key.
1. Switch off ignition and remove ignition key.
Unscrewing fastening screws for tilt sensor conrol unit
2. Unscrew the two fastening nuts -1- and remove the tilt sensor control unit.
3. Remove the two sheetmetal nuts -2- from the tilt sensor control unit.
Removing plug for tilt sensor control unit