911 Carrera (997) F6-3.6L (2006)
6.5 Connect standard antenna connector from diversity control unit (angled) --> Figure 20 -D- and antenna connector (straight) from the antenna
line (retrofit kit) --> Figure 20 -C- to the control unit --> Figure 20 -A-.
Plug in wire harness connector --> Figure 20 -B- and tighten locking screws.
6.6 Pull protective film off the double-sided adhesive tape on the control unit --> Figure 21 -A-.
6.7 Insert control unit --> Figure 22 -A- at the left in the PCM installation slot and press on it so that the angled antenna connector --> Figure 22
-C- is positioned between the bars of the installation slot --> Figure 22 -B-.
6.8 Wind up the rest of the wire harness (retrofit kit) and route it in the side area of the center console --> Figure 23.
7
Connect wire harness (retrofit kit).
WARNING:
Working on the vehicle electrical system
-
Risk of short circuit and fire.
--> Disconnect and cover the battery.
--> Route electric wires without tension so that no chafing occurs.
--> Secure electric wires to existing wires/components using tie-wraps and/or wrapping tape.
7.1 Disconnect the battery. --> Workshop Manual '2X00IN02 Work instructions after disconnecting the battery'