porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Audio System - 4 CD Changer Installation Instructions|Page 5087 > < Audio System - 4 CD Changer Installation Instructions|Page 5085
Page 5
background image

Secure CD autochanger retaining frame with two screws --> Figure 10-A-.

NOTE:  Figure 13 shows the connectors (Items A, B and E) for the RoW version of the navigation unit (CD changer and navigation unit
arranged one on top of the other).

4.3

Plug electric connectors --> Figure 13-C- and optical waveguide --> Figure 13-0- into the CD autochanger until they are felt to engage.

NOTE:  Figure 14 shows the RoW version of the audio components (CD changer and navigation unit arranged one on top of the other).

4.4

Position CD autochanger with support onto the mounting point and push it towards the front panel until the CD autochanger support clicks into
place.

5. Concluding work

5.1

ONLY for vehicles with luggage compartment cooling:
Install air guide.

5.2

ONLY for vehicles with Tire Pressure Monitoring control unit:
Insert Tire Pressure Monitoring control unit and tighten fastening screws. --> Workshop Manual '443419 Removing and installing Tire
Pressure Monitoring control unit - section on "Installing"

5.3

Install luggage compartment cover and tighten plastic screws. --> Workshop Manual 703019 Removing and installing luggage compartment
cover - section on "Installing"'

5.4

Connect battery charger.

5.5

Code CD autochanger.

5.5.1

PIWIS Tester P 9718 must then be connected and ignition must be switched on.

NOTE:  For additional information and instructions on carrying out the menu items, see --> Workshop Manual '911019 Removing and
installing PCM display and operator control unit - section on "Programming"'.

5.5.2

Select "GATEWAY" control unit and "Coding" function selection. Press «F12" to continue.

5.5.3

In the "Gateway coding" menu, select Required installed components lists and press «F8" to change the CD autochanger coding to Installed.

5.5.4

Select "PCM 2.1 "control unit and "PCM 2.1 MMI" function selection.

5.5.5

In the "PCM 2.1 MMI function selection" menu, select Planned & Actual configuration and check that the CD autochanger is configured.

Audio System - 4 CD Changer Installation Instructions|Page 5087 > < Audio System - 4 CD Changer Installation Instructions|Page 5085